Rebuild for a Friend Joe. Took Apart to Clean.
Dirty and Rough.
Put the Bed on the Mill to Take Out Rough Spots on the Casting.
Milled a Flat Spot for Clamping Plate.
Cleaned and Greased the Chuck.
Gear Train and Pulley before Cleaning.
Pulley Off
Gear Train, Except Lead Screw Gears, right side.
2 Sheets HDO 3/4 Inch Plywood Glued Together.
Motor Mount and Belt Tensioner.
I made a Carriage Stop.
Cleaned and Back Together and Running
Clean Plate
Making Tool Bit Holders For KDK Quick Change Holder
Testing the Fit Before Putting in the tool slots and Tapped Holes.
Made Chuck Key, Making Chips!
Using the Compound.
This is a Good Tool, Used Within it's Limits, as with All Tools.
Motor
Close Up of Wiring Diagram.